Cuplock quantity planner

From slab dimensions
to a coded enquiry.

Configure the grid using your engineer-selected component sizes, calculate geometric quantities and send the exact Vidaform codes to the catalogue enquiry. This tool counts components; it does not make structural design decisions.

01 / PROJECT GEOMETRY

Define the slab zone

Enter the clear plan dimensions. Geometry updates immediately and feeds the Cuplock grid below.

LengthmWidthmSlab depthmOpeningsm²

NET AREA108.00m²

PERIMETER42.00m

CONCRETE VOLUME21.60m³

02 / CUPLOCK QUANTITY PLANNER

Configure the grid

You choose every component size and ledger level. The planner only performs geometric counting—it never selects structural spacing.

Nominal support height (before jack adjustment)mStandard componentLedger / bay length — XLedger / bay width — YCount loose spigots at stacked-standard jointsUses one VID-CUP-SPG per geometric joint. Disable if the approved standard connection does not require a loose spigot.Ledger levelslevelsBase componentHead componentUser allowance%

7 bays / 12.60 m8 bays / 9.60 m72vertical positions

2standards / position3ledger levels0%user allowance

Geometry checkGrid covers 12.60 m × 9.60 mBoundary overrun: 0.60 m × 0.60 mNominal standard stack: 4.00 m; jack adjustment is not modeled

03 / GENERATED QUANTITIES

Review before enquiry

These quantities follow your selected geometry and components. Review the covered dimensions and exclusions before sending.

Item codeComponentCounting logicQty

VID-CUP-STD-2000Cuplok Standards — 2.00 m72 positions × 2 standards144

VID-CUP-LDG-1800Cuplok Ledger — 1.80 m7 bays × 9 rows × 3 levels189

VID-CUP-LDG-1200Cuplok Ledger — 1.20 m8 bays × 8 rows × 3 levels192

VID-BAS-UNJ-0750Universal Jack 750mm1 per vertical position72

VID-BAS-UHJU head Jack Solid1 per vertical position72

VID-CUP-SPGCircular Loose Spigot72 positions × 1 stacked joints72

Total planned quantity741

ENGINEERING COMPLETION CHECKLIST

Required before this becomes a complete project quantity.

Not countedDiagonal bracing and plan bracing

Not countedTies, anchors and stability restraints

Not countedDecks, intermediate transoms and access

Not countedGuardrails, toe boards and edge protection

Not countedFoundations, sole boards and bearing checks

Not countedErection sequence, inspection and rescue provisions

Required engineering review: This tool does not determine or approve bay spacing, loading, capacity, bracing, ties, stability, foundations, erection sequence or safe use. Braces, decks, transoms, access and project-specific accessories are excluded. A qualified temporary-works engineer must review the complete arrangement.

One connected workflow

Geometry → quantities → catalogue → WhatsApp.

Open catalogue ↗